Custom 4.5Ft Long Tube Tri-Y * The Saga *

[ProTools4]

no more time to mess with TCC lockup

car is packed
now heading to Irwindale

[ProTools4]

Had a good time at the drags
did two runs

Ryan (from LS1tech)
Nick & Shawn (from the Impala forum)

all came out an supported me in my runs.

Full details in the morning
with pictures, datalogs, and videos if Shawn puts them up!

So much fun!

[ProTools4]

Shawn ...

you da Man!

YouTube- J5 Irwindale 1_7_10

YouTube- J5 Irwindale 1_7_10

this is rolling the throttle on
50% TPS @ 10 MPH
100% TPS @ 19 MPH

1.734 - 60'

[ProTools4]

fun fun fun

I like these pictures cause you can't see were my pops backed into my car :-)

[9C1 Newbee]

FWIW, top end in both cars had issues. Replacing the MAP rubber seal located below the map sensor sure made a difference.

[ProTools4]

Originally Posted by 9C1 Newbee

FWIW, top end in both cars had issues. Replacing the MAP rubber seal located below the map sensor sure made a difference.

where did you get the new seal?

[FearTheDeer]

I haven't been in over a year I miss the atmosphere at the track. Though it was pretty packed last night. 1.5hour wait in between races

[ProTools4]

Originally Posted by LeadSSled

Tad - It always feels slow when the tires are spinnin' Been there, done that. Bolt the slicks to it and THEN tell us what you feel.

Ok, Terry you were 100% correct.

on the street it is actually pushing thru the 285s in 2nd making it feel slow.
It was pretty insane in 2nd with the 335s at irwindale.

[ProTools4]

anyone want to take a stab at calculating the HP difference from my previous best 1/8 time to this 1/8 time?

[ProTools4]

hate to break things up but it though it was more appropiate in the performance section

disscuss the differences in stats over here

http://www.impalassforum.com/vBullet...47#post2229247