So my engine has the Torqhead installed (crank hub), the transmission is done and it was finally time to put the engine back in this weekend. I failed. My lifting chain was done all wrong and I ended up 2 inches short of getting on the motor mounts. The chain was hitting the firewall cowl, and...

The crankshaft seal is leaking oil. I was using a puller today to try to remove the hub sleeve after removing the balancer pulley. When cranking on the center puller extractor bolt the hub moved to the right to about the one 0'clock position from the 12:00 position. The Hayne's manual says not...

Hello, I have a persistent issue with my 96 B4U that I've been trying to diagnose for months now. This was compounded with a similar issue that I fixed awhile ago with a fresh C&R. Currently, if I accelerate gently from a stop initially, I can quickly get into the throttle and it's smooth all...

Hello everyone, tell me if this installation will work in stock lt1 Cam: Xtreme Energy 212/218 Hydraulic Roller Cam for GM LT1/LT4 RPM Operating Range: 1,200-5,200 Grind Number: 264HR-12 Cam Type: Hydraulic Roller Lifter Style: Hydraulic Roller Advertised Intake Duration: 264 Advertised Exhaust...

It just occurred to me that the wood section doesn't have a single sticky. I would like this compilation thread to be one... but first we need contributions. The reason i ask for only larger than stock is because if you want to see smaller you can just go to cusstom.com and look at about a...