Chevy Impala SS Forum banner
1 - 6 of 6 Posts
G

·
Discussion Starter · #3 ·
Kinda matches the front...I'm diggin' it!

Were they grafted on, or did you heat up the original cover and form them?
 
G

·
Discussion Starter · #4 ·
I grafted them on, I cut them off a sedan rear bumper. So they would match the fronts like MILKr8 stated.

The license plate will stay where it is. If you hadn't noticed, I also filled in the groove/bodyline.



[ 06-29-2007, 10:28 AM: Message edited by: 1967 Big daddy ]
 
G

·
Discussion Starter · #6 ·
Yeah it does, I centered the bumper guards on the bumper,and when we stuck it on the car, the license plate holes give the illusion that they aren't center.

So when we install our plate we will favor the other side.

GOOD EYE!
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top