Chevy Impala SS Forum banner

1 - 7 of 7 Posts

·
Premium Member
Joined
·
1,808 Posts
Discussion Starter · #1 ·

·
Registered
Joined
·
1,242 Posts

·
Registered
Joined
·
372 Posts
I used a set on my old iron heads when I was running the Comp Pro-mags. I ended up grinding the crap out of the extra material between the center bolt hole and the inside edge. I don't run them any longer and will sell them to you for $30 and I'll pay shipping.
They are by now means brand new and free from scratches....see below.




 

·
Registered
Joined
·
372 Posts
the passenger side especially has some deeper scratches towards the rear.
I used the thick blue silicon rubber gaskets and never had any leak issues.
 

·
Registered
Joined
·
6,443 Posts
I have a set form my Vortec 906 heads.

Excelent covers, very thick, they appear to be the same covers.
 

·
Registered
Joined
·
1,297 Posts
What kind of breather did you use on these covers? Just any old breather will do? Gotta get a grommet for the breather too....
 

·
Registered
Joined
·
6,443 Posts
What kind of breather did you use on these covers? Just any old breather will do? Gotta get a grommet for the breather too....
Havent installed them yet, but I will use old breathers might do an evac to the header unsure.
 
1 - 7 of 7 Posts
Top