[Guest]

Hey everyone. I have a question about the adj upper control arms. I have my pinion angle set right, but I think the spacing on each arm is off. therefore throwing the rear axle out of alignment. I cant seem to get the spacing on each arm the same while maintaining the pinion angle. any suggestions?

thanks
Len

 

[Guest]

I haven't seen these arms, but I would imagine that if you turn each adjuster the same amount (1/4 turn, 1/8 turn, etc.) in opposite directions, your pinion angle shouldn't change, but the axle housing will shift to one side or the other.

 

[Guest]

thanks I was in the process of doing that but could not keep the angle right.

 

[Guest]

Can someone tell me how you got your pinion angle so you say its right? I cant get peace of mind with my aftermarket setup until I know. Thanks if you can help me

 

[Guest]

I would also like to have peace and mind,iam throwin a new axle with extendend arms,i would love a detailed explanation on getting the pinion angle correct.