Chevy Impala SS Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
435 Posts
Discussion Starter · #1 · (Edited)
was already installed when i got the car. it worked fine (front and rear) but i had it removed bc the hazards only worked with ignition on. info and instructions here. can be set up with hazards working properly.

various wires have been cut and it comes minus the 2 bulb sockets bc taillight holes have already been enlarged for them and if i take them out i can't put the regular bulbs back in. $85 shipped OBO, it's $171 shipped new. please don't send me PMs, email me. PHOTO.
 

·
Registered
Joined
·
435 Posts
Discussion Starter · #3 ·
thanks for that info. so i guess this is jerry's kit minus the #2057 lamp sockets (which are in the car).
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top