Chevy Impala SS Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
262 Posts
Discussion Starter · #1 ·
Hey guys just wondering if there's a good replacement for the stock rubber Elbow that connects to the TB. Right now i have the top capped off and clamped where Homeplate used to connect to it, and i have a K&N FIPK. Just wondering what options there are to replace it. On my '95 Z28 i had a 1LE elbow (i think it was called), but not sure if those fit these LT1s/throttle bodies.
 

·
Premium Member
Joined
·
8,454 Posts
On my '95 Z28 i had a 1LE elbow (i think it was called), but not sure if those fit these LT1s/throttle bodies.
that's the one you want.
 

·
Registered
Joined
·
534 Posts
Trick Flow & Vortech also make Inlet elbow replacements for the LT1.
Check Summit or Jegs...
 

·
Registered
Joined
·
3,271 Posts
Hey guys just wondering if there's a good replacement for the stock rubber Elbow that connects to the TB. Right now i have the top capped off and clamped where Homeplate used to connect to it, and i have a K&N FIPK. Just wondering what options there are to replace it. On my '95 Z28 i had a 1LE elbow (i think it was called), but not sure if those fit these LT1s/throttle bodies.
I went to Home Depot and got Rubber Plumbing Fittings and clamps.

ON the 95SS
The TB is mounted in a straight through direction.
The Cone Air Filter touches the radiator.

ON the 94Wagon
Have a 90 degree elbow and tube going to the stock air filter.

Spent less than $10

Dan
 
1 - 4 of 4 Posts
Top