Chevy Impala SS Forum banner
1 - 5 of 5 Posts
G

·
Discussion Starter · #1 ·
My 96 right front is leanning about 1/4 inch lower than the left. I looked under and it seems that my sway bar is severely scraped from the tire when I turn the wheel completely to the left. I have 20's but it does it with stocks as well. What could be the cause? Could it bad sway bar busshings? Please help.
 
G

·
Discussion Starter · #2 ·
its possible one of your springs are worn out more
then the others. mine was leveled after i replaced
my springs.
 
G

·
Discussion Starter · #3 ·
the misterious leaning to the left/right....

mine does that too ( I'll tchek that next pring when I redoo my suspension bushing)

Is your car dropped? maybe a bad spring alingment ( thats what I am hoping for )
 
G

·
Discussion Starter · #4 ·
Mr. L, my stock 9c1 shocks were jacked up, my passenger
front was lower by an inch. after i had my st springs
swapped in, they evened out much closer. was the
the spring isolators tie wrapped onto the spring
when the H&Rs were put in? H&Rs are good quality.
 
G

·
Discussion Starter · #5 ·
I poped them in last summer...I did it myself but regret not swapping suspension bushing at the same time...so I think I maybe did not correctly aligned then in...we will see next spring!

yeah H&R is a really good spring manufacturer (porche trust them for their race cars so...why no us?)
The drop is significant on the ss, nice stance and look..
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top