Joined
·
11 Posts
Need someone who can flash my pcm on my 1994 OBD1 SS. Ct area 06460
Thanks in advance
Thanks in advance
Local tuner needed for obd1 near 06770
1 - 2 of 2 Posts
Joined
·
2,907 Posts
Hi,
i did mail order but
https://www.impalassforum.com/vBulletin/11483130-post23.html
He's in Manchester.
Send him a PM to get his email and see if he can help you.
-ALF out....
i did mail order but
https://www.impalassforum.com/vBulletin/11483130-post23.html
He's in Manchester.
Send him a PM to get his email and see if he can help you.
-ALF out....
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Custom motor needs a tune......
PCM Programming/Engine ManagementIt's been years but in back and have another wagon))))) I have a custom LT4 I'll be installing but the owner scrapped the computer with the original car. I'm trying to get info from the builder but since it's an older build they said they may not be able to help find any original info...- 3
- 244
-
Engine
PCM Programming/Engine ManagementWant more horse power...engine swap or rebuild engine...94 impala 350 5.7- 5
- 292
-
[email protected] · updated
-
$EEHACK 94-95 LT1 tuning/flashing datalogging on CHEAP!
PCM Programming/Engine ManagementDid a search and found nothing in regard to this program being mentioned on this forum. With a $4 usb converter off eBay + $EEHACK read/flash/datalog. Also a very good TunerPro $EE.xdf for TunerPro .bin editing. http://fbodytech.com/eehack-2/ Check it out.- 32
- 10K
-
babywag · updated
-
Scan9495 or eeHack? Use both.
PCM Programming/Engine ManagementI was chasing down an issue where my car's TCC would not lock up. I hooked the car up to eehack and drove it around and could not see anything wrong. Checked the trans flags in eehack while looking at the log and didn't see anything wrong. Used the TCC trigger capability in eehack to get it to...- 0
- 200
-
411 PCM swap
PCM Programming/Engine ManagementI’ve been chasing a misfire for a couple weeks now. #3 is cold, plug is fouled and all signs are point to the optispark again. I’ve been reading online about how the optispark can function in batch mode without high voltage parts (like vortec truck motors do) if connected to a 411 pcm...- 10
- 709
-
GreenWitINv · updated
Join now to ask and comment!