Chevy Impala SS Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
983 Posts
Discussion Starter · #1 ·
I've got a 55K LT1 short block out of a 94 Roadmaster. It was a good running motor out of a friends car. I was going to use it for my 84 Monte LT1 swap, but I since have found a cheap forged rotating assembly.

Rather than pull apart a perfectly good shortblock, I figure I could help somebody out by trading for your blown/worn out short block. I have to punch it out .060" and put in new main caps anyways so as long as there are no cracks or stripped threads I'd be fine with whatever you got. Mine is a little crusty and has some surface rust on the #1 cylinder wall, didn't effect how it ran and is probably just from sitting so long.

I was thinking a core and throw $125 my way would be a fair trade. I would trade straight up for a clean .060" over block.
 

·
Registered
Joined
·
2,026 Posts
hmm... since ur in ohio i got a shortblock but i dont really need anothern. gimme a holler. 7402270080
 

·
Registered
Joined
·
751 Posts
I have a bare block, but the rust comment makes me nervous...does it look like it needs to be machined?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top