Chevy Impala SS Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
322 Posts
Discussion Starter · #1 ·
I have a 96 impala and will be moving to Phoenix in March. I have LE2s, a 58mm ported intake, comp cam, CIA try-y headers with high flow cats, pypes-X, and mufflers without resonators. My air pump was removed a long time ago. Any insight you guys can provide of potential issues I may encounter would definitely be helpful.
 

· Registered
Joined
·
322 Posts
Discussion Starter · #3 ·
those are very good questions. hopefully one of the Arizona guys will chime in since I'M not there yet. Ive down some preliminary research but its all so foreign to me since Ive never had to worry about it here in NM
 

· Registered
Joined
·
322 Posts
Discussion Starter · #5 ·
They have only plugged mine in and checked for codes, never opened the hood. They will also check the gas cap. Pretty much set if the CEL isn't on & no codes are stored.
Thanks Gregg-O, that makes me breathe a little easier.


Cam info is as follows
226/232 .578/.574 110 LSA. – 1900-6200 RPM
 

· Registered
Joined
·
322 Posts
Discussion Starter · #7 ·
I'm most likely going to move downtown Phoenix. The had cap comment had me laughing and I'm sure I will laugh when they tell me I need one. My throttle body is a TPiS that was recently installed so hopefully I won't have any issues. My CEL is throwing the P0200 fuel injector malfunction code but I will have a shop address that this week. I look forward to meeting you guys. There were few b-body's here in las cruces nm besides mine and my brothers so I'm definitely looking forward to meets and going cruising
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top