Chevy Impala SS Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
2,999 Posts
Discussion Starter · #1 · (Edited)
After 17 years the Pinion seal took a dump on the Custom Cruiser thus making a mess allover the place.

How does one replace this seal? I never done one, nor took apart an 10 bolt. Are any special tools required? Puller needed for the yoke? Also, is their a crush sleeve and is that a 1 time use part?

To get the old seal out I dont have to remove the pinion right?



LMK. Thanks.
 

· Registered
Joined
·
297 Posts
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top