Chevy Impala SS Forum banner
1 - 1 of 1 Posts

· Registered
29 Posts
Discussion Starter · #1 ·
It was removed from a 95 9C1 with approximately 50,000 miles on it. It's a non-posi unit with the factory 3:08 gears. I purchased it back in 1998 and never used it.

Since the purchase I installed upper urethane bushings, painted the housing with black with POR 15, and replaced the outer axle bearings and seals. The images show that the condition of the axle bearing surfaces along with the ring gear is in good condition. This unit won’t come with the rotors or calipers. The brake lines are included. I’m asking $200.00 or best offer which does not include shipping. Local pickup preferred because I don’t know of any shipping companies.

Checkout the images.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.