Chevy Impala SS Forum banner

1 - 8 of 8 Posts

·
Registered
94 Roadmaster Wagon
Joined
·
4 Posts
Discussion Starter #1
Hello Guys, I´m new here and I´ve heard from a guy who offers aftermarket seat slider kits for B-Bodies. On my 94 Roadmaster they are worn and the seats are rocking with every braking. My wife is fed up with .....please drop a post whoever knows something about. Please don´t refer to guys who maybe well known here in the forum, I´m German and I don´t know anybody at all here. Thanks a lot for your help !

GerRoadie
 

·
Registered
Joined
·
11,396 Posts
There used to be a company that made them, but they appear to no longer be in business. If you can get a good one, maybe someone can replicate it on a 3D printer.
 

·
Registered
94 Roadmaster Wagon
Joined
·
4 Posts
Discussion Starter #7
I´ve got no response from 3gsperformance via Email, I´m German and today I called them by phone, but was only the answerphone. Does somebody know if they are operating at all, any issues with Covid or something?

For sure I will post as soon as I´ve fixed it. Hopefully the parts are ok. I´ve put it apart today, all sliders are brittle. I´ve measured the dimensions as far as possible, seems that the sliders are relativly soft to overcome the big tolerances of the steel rails, these are not precious. Some 1/10mm differences. If the replacement parts are harder than the old ones, maybe they won´t slide without violence and should be prepared by sanding to get work. F***ing detail work. I was already talking with some specialists over here to print them in 3 D if the shop doesn´t response.
 

·
Registered
Joined
·
6 Posts
I´ve got no response from 3gsperformance via Email, I´m German and today I called them by phone, but was only the answerphone. Does somebody know if they are operating at all, any issues with Covid or something?

For sure I will post as soon as I´ve fixed it. Hopefully the parts are ok. I´ve put it apart today, all sliders are brittle. I´ve measured the dimensions as far as possible, seems that the sliders are relativly soft to overcome the big tolerances of the steel rails, these are not precious. Some 1/10mm differences. If the replacement parts are harder than the old ones, maybe they won´t slide without violence and should be prepared by sanding to get work. F***ing detail work. I was already talking with some specialists over here to print them in 3 D if the shop doesn´t response.
I sent you a PM
 
1 - 8 of 8 Posts
Top