[jeffrobodine]

http://www.flickr.com/photos/jeffprice767/5082026371/in/photostream/

http://www.flickr.com/photos/jeffprice767/5082026347/in/photostream/

I'm trying to reassemble my seats. Top black thingie is attached (barely) by a plastic brad/screw at each end.

I tried screws that I stuffed in the same ziploc as the black thingies, but they don't seem to thread right.

 

[Carlton]

Those are the right screws, but those bottom pieces don't go on that rail, they go onto the bottom bracket where the bolts attach to the floorpan. You press them into the carpet and then the one screw will hold them down properly.
As far as I know, nothing goes into that one hole you have the screw threaded in to.

 

[jeffrobodine]

there are holes in the metal floorpan for them or do they just thread into the carpet? 'Cuz the holes are long lost to imitation Dynamat.

 

[Carlton]

No, the hole is in the lowest seat bracket. Once the seat is bolted in, put the cover over the bolts and it will be obvious.

 

[Mean SS]

their are plastic ends for slider channel