[Roofgoof]

Looking for help. I have 1994 caddy fleetwood chassis LT1 under this 52 Buick. I want to place steel braided transmission cooler lines on it but cant find what I need.

 

[91ss]

PM 1slow96

 

[Z09B4U]

Just about any area has a hydraulic shop to repair industrial and farm equipment. If you need help this would be the place to start.

Here are some links:

Transmission cooler lines

Do anyone know what type of fittings i will need If i wanted to add stainless braided transmission/oil cooler lines?

www.impalassforum.com

stickied: 4DOOR's Trans Cooler Line AN Conversion

After recently converting Engine Oil Cooler Lines to AN fittings and Braided, I decided to replace the Trans Cooler Rubber Lines too. More info on that conversion and the Parts/methods used in this post… http://www.impalassforum.com/vBulletin/showpost.php?p=11481906&postcount=79 As most...

www.impalassforum.com

 

[gbhs72]

My intent is to run short stainless steel braided lines to the frame and then run the high side into a sending unit manifold and the return line will be SS 3/8th inch to the radiator & cooler. Both lines will be hard at the frame. I think that may look cleaner than the flexible line all the way to the rad. There are kits for installing the entire flex line. Be sure to route the lines correctly.

Mark: Snowman-33