Chevy Impala SS Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
9,010 Posts
If you want to change over without going into the case there may be an approx. $450 Quicktime or McLeod adapter/bellhousing application. It may allow you to retain your existing puller slave cyl. configuration too, - or not. Just a thought.
 

·
Registered
Joined
·
9,010 Posts
....

But with this setup wouldn't you have to use that funky pilot bearing that is like 2 inches long or something, I am going on memory here but I remember something like that.
That's the "-or not" part of my comment. But if you're able to find a properly configured adapter bellhousing from either of those two suppliers and keep the LT- style trans faceplate and input shaft, then I don't see why you could not reuse the LT- puller style slave cyl. as well.

FWIW, there's livid debate by fellas who much prefer the 'funky' LS- pusher style throwout bearing over the LT- setup.

Pics of both types of tranny faceplates - just to confuse the issue further.
 

Attachments

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top