Chevy Impala SS Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2,171 Posts
I measured and then had Magnecore custom make me my wires. Also running a $40 set of junkyard coils with no issues.

-Brian
 

·
Registered
Joined
·
2,171 Posts
So long ago at this point I A) don't remember and B) it probably has zero comparison to post covid shipping times.
 

·
Registered
Joined
·
2,171 Posts
24x can be done cheaper than the TorqueHead kit if you're not afraid of wiring and junk yard parts and with my very aggressive cam the 0411 PCM has some additional parameters such as dwell which allowed me to achieve much smoother operation at low throttle low speed conditions.

-Brian
 

·
Registered
Joined
·
2,171 Posts
Don't you lose sequential injector control with the 4x crank-only conversion, which then precludes your ability to delay injector timing until after exhaust valve close at idle?
I did the cam and crank sensors. (EFI Connection). I already HP Tuners for my GTO so I figure my spend was ~$700 in parts and another $2-300 in tuning. What's a good Opti replacement cost these days?

-Brian
 
1 - 4 of 4 Posts
Top