Chevy Impala SS Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
61 Posts
hello
i see you put the end link in the slot for the crossbrace, do you have to drill a hole for the endlink to fit, and if so, what size drill bit did you use, and is there enough of the bushing on the top to hold it all in place? (it looks by the pic only one side of the bushing is holding)

i read some drill the existing holes near the cross brace bigger, what size drill bit for that? and is it better to use existing slot, or re drill existing holes?

is it just preference or is one way easier
thanks
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top