Chevy Impala SS Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
177 Posts
Any one have experience with this Addco bar?

Ebay Item number: 120351412998
 

· Registered
Joined
·
177 Posts
Installed the 21mm CV sway bar today.
The hardest part of this job is drilling the 2 -3/4" holes in the crossmember for the end links. The CV bar fits perfectly,with plenty of clearance to all other parts.
Bought the bar new from the local Ford dealer for$56.65 + tax .This is cheaper than On line where you have to pay shipping charges.
All included total cost was $107.21 for bar ,end links,bushings and clamps.
A bargain for the improvement in handling. Wagon takes corners like it was a 2009 model. Hard to believe GM did not do this as a factory standard.

Also replaced original halogen headlights with Sylvania Silverstar Ultra headlights bulbs 9004 SU .Purchased on Ebay, $19.49 for 2 bulbs,free shipping.
At least 50% brighter than stock bulbs.

So now I can take the curves faster and see where I am going.
 

· Registered
Joined
·
177 Posts
Could you post the part#'s for all this stuff?
Exactly as stated in 1st post of this thread.
Sway Bar: Ford YW7Z-5A772-CA
End Links: Energy Suspension 9.8125 ENS-9-8125R
Bushings: Energy Suspension 9.5157 ENS-9-5157G
3” exhaust clamps: Summit SUM-G4730 SUM-G4730

Purcased the 3" clamps from autozone ,Bushings and end links on line from energy suspension, and bar from local ford dealer.
 

· Registered
Joined
·
177 Posts


Nut looks loose on U bolt



Slot is not the strongest attachment point.
Enlarge the hole in the cross menber for a stronger attachment. I used a 3/4" drill, but 11/16" would be better.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top