Chevy Impala SS Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,094 Posts
The only tool you need is a small short nail or drill bit, etc. Slightly lift the arm......notice the small hole near the pivot point.......insert nail in hole (both sides - go through) to hold arm up......remove nut cap and nut.......pull arm off. Agreed - good time to switch to the LeSabre/Bonneville arms.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top