Chevy Impala SS Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,739 Posts
Discussion Starter · #1 ·
Slowly (but steadily) gathering parts for the 240Z swap.

Looking for a GOOD wiring harness for an LT1/4L60E engine swap.

Not sure what all matters, but this will be an OBD1 program and the trans is a 4L60E from a 1994 Camaro.

Please let me know!

Thanks,
Tim
 

·
Registered
Joined
·
1,739 Posts
Discussion Starter · #3 · (Edited)
I've got you covered. I have a 95 SS harness boxed up and ready to go, dropping you a PM right now.

Doug

Thanks Doug! I am responding before I see your PM.

Does anybody know if the 94 to 95 harness is any different from a "transmission" point of view? When I bought this trans, the guy said that the 94 and 95 and up 4L60E's had a different solenoid setup (1 for 94 and 2 for 95+). Something to do with different lock up capabilities. Just wondering if I will get any issues since this is from a 94' with the single solenoid.

Maybe it is something that can be programmed out...

Thanks!
Tim
 

·
Registered
Joined
·
1,739 Posts
Discussion Starter · #4 ·
Sorry Doug! Another (Doug) over in the Z28 Forum had the actual Z28 harness I was looking for (94' Camaro w 4L60E) and I should have checked first!

Per my PM, I am still looking for other parts and will be happy to sending you some of my money! :D

Needless to say - I have found a harness. Thanks all!

Tim
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top